How to Replace Burst 3/4 Brass Ball Valve

When talking about replacing burst 3/4 brass ball valves we need to first think about why the replacement is needed in the first place. In most cases we are dealing with a crack in the 3 quarters of an inch brass ball valve. We can not really fix it so we do need to put another one back in. This is where we can have a problem. Most individuals will end up removing the old brass ball valve but can not put back a new one. This is because both threads on the valve look like female and come with standard threading. If you turn it clockwise it tightens and counter-clockwise it un-tightens. The real problem, as it is seen by most people, is how to get the male ends of the two pipes to connect at the same time. We are faced with one tightening and the other one getting looser.

The proper way to handle the situation is not difficult. You will need to return an attached threaded pipe to the union and simply connect the loosely threaded pipe to your ball valve. After this you have to reassemble the pipe and valve to the hanging pipe. When this is done the next step is reconnecting this union to the other side of the system. You will also need two HD pipe wrenches. These are used at the same time to break the union and eventually retighten it after the brass ball valve was replaced with a new one.

The real problem with this scenario is that the brass ball valve cracks. This is most likely because of it getting frozen. As time passes you will end up having to replace the 3/4 inch brass ball valve every year as it will always crack unless you can have a way to drain the entire line at the end of summer. The best solution would be to move it into a heated portion of your home or somewhere where it is hot and it can be turned off in order for the line to be drained.

Also, in some cases you will need the help of a plumber. A lot of houses with such pipe systems were built and they need to have a union installed in the line as it is sometimes necessary and could help you out. Think about the fact of consulting a specialist because there is a big chance you will waste a lot of time trying to figure it out. Looking at what the plumber does will at least give you an idea of how to do it properly in the event it happens again.

brita water purification plumbing venting how to replace hayward superpump problems blocked trap checking waste drain