Why Does My Valve Clunk?

Talking about the clunking sound of a valve is somewhat difficult because there are different possibilities. In most cases we are dealing with a clunking sound that is caused by a loose washer in the faucet. If this is the case and you suspect it you should just go at your faucet and tighten the loose washer. The clunking sound should stop. If you still notice it happening you should go for a more thorough analysis. The clunking sounds can usually be heard when the water is turned on and off.

Talking about single handled faucets, you need to know that they are currently the best selling kitchen faucets on the market. They come with an obvious advantage when compared with over side sprays, mainly because they come with a higher volume spray delivered. On the other hand, side sprays draw water from a small opening located on the side of the faucet so this creates a lack of pressure and volume available with a pullout model. When it comes to hoses, they do vary in length and can appear as long as 54 inches. Stainless steel hoses will come with less kinking but will also appear with more noise. A lot of models will utilize weights to retract the hose and this will immediately translate in a clunking sound when it is released abruptly. A smoother operation is offered by other models that show spring loaded hoses. This is why you also have to think about the fact that your clunking sound can be normal and it is not always a sign that something is going wrong.

It is very important to realize what type of faucet we are talking about. Common models will show a mix between cold and hot water. When you turn the handle towards hot you usually get cold water at first and then there is a clunk sound heard. The hot water then immediately appears and it is usually to hot to bear so pay attention not to get burned. This is exactly a normal reaction from some water faucets that come equipped with spring loaded mixing valves, for both hot and cold water. The good news is that most models can be adjusted so that there will be less pressure on the spring, thus removing both the clunk sound and the possibility of getting burned.

ridgid aluminum pipe wrenches plumbing schools plumbers training kero world 23 000 btu kerosene convection heater pool use antifreeze adding toilet second